Download 2000 Audi A4 Sedan V6-2.8l Instrument Cluster Removing & Installing NOTE: – Do not disassemble instrument cluster. – Removing the steering wheel is not required. For clarity, the steering wheel does not appear in the following illustrations. – Check DTC memory before removing the instrument cluster. – Also check and write down values of the service display and the odometer reading via the VAG1551 scan tool. Removing – Using the adjustment mechanism, move steering wheel fully out and downward. – Tilt upper cover forward an remove upward. – Flip trim -1- toward front. Remove both Phillips-head screws -2-. Pull out instrument cluster toward front. Cut cable ties at rear of instrument cluster. Unclip securing latches of connectors and disconnect connectors. Installing – Connect electrical harness connectors and affix wiring harness to rear of instrument cluster with cable ties. To install, perform the steps described for removal in reverse order. Perform a function test after installation. If function test is OK observe notes for the replacement of the instrument cluster.